Ultrafast pulsed lasers fuse ceramics under ambient conditions and use less than 50 watts of power.
environments. These could all be made possible thanks to a new ceramic welding technology developed by a team of engineers led by UC Riverside and UC San Diego.
The process, published in the Aug. 23 issue of Science, uses an ultrafast pulsed laser to melt ceramic materials along the interface and fuse them together. It works in ambient conditions and uses less than 50 watts of laser power, making it more practical than current ceramic welding methods that require heating the parts in a furnace.
Ceramics have been fundamentally challenging to weld together because they need extremely high temperatures to melt, exposing them to extreme temperature gradients that cause cracking, explained senior author Javier E. Garay, a professor of mechanical engineering and materials science and engineering at UC San Diego who led the work with UC Riverside professor and chair of mechanical engineering Guillermo Aguilar.
Ceramic materials are of great interest because they are biocompatible, extremely hard and shatter resistant, making them ideal for biomedical implants and protective casings for electronics. However, current ceramic welding procedures are not conducive to making such devices.
“Right now, there is no way to encase or seal electronic components inside ceramics because you would have to put the entire assembly in a furnace, which would end up burning the electronics,” Garay said.
The team’s solution was to aim a series of short laser pulses along the interface between two ceramic parts, so that heat builds up only at the interface and causes localized melting. They call their method “ultrafast pulsed laser welding.”
To make it work, the researchers had to optimize two aspects: the laser parameters (exposure time, number of laser pulses, and duration of pulses) and the transparency of the ceramic material. With the right combination, the laser energy couples strongly to the ceramic, allowing welds to be made using low laser power (less than 50 watts) and at room temperature.
“The sweet spot of ultrafast pulses was two picoseconds at the high repetition rate of one megahertz, along with a moderate total number of pulses. This maximized the melt diameter, minimized material ablation, and timed cooling just right for the best weld possible,” Aguilar said.
“By focusing the energy right where we want it, we avoid setting up temperature gradients throughout the ceramic, and we can encase temperature-sensitive materials without damaging them,” Garay said.
As a proof of concept, the researchers welded a transparent cylindrical cap to the inside of a ceramic tube. Tests showed that the welds are strong enough to hold vacuum.
“The vacuum tests we used on our welds are the same tests that are used in industry to validate seals on electronic and optoelectronic devices,” said first author Elias Penilla, who worked on the project as a postdoctoral researcher in Garay’s research group at UC San Diego.
The process has so far only been used to weld small ceramic parts that are less than two centimeters in size. Future plans will involve optimizing the method for larger scales, as well as for different types of materials and geometries.
The paper, “Ultrafast Laser Welding of Ceramics,” is published in Science. Co-authors include A. T. Wieg, P. Sellappan, and Y. Kodera, UC San Diego; and L. F. Devia-Cruz, P. Martinez and N. Cuando-Espitia, UC Riverside. DOI: 10.1126/science.aaw6699
This work was funded by Defense Advanced Research Projects Agency (DARPA contract HR0011-16-2-0018), the National Science Foundation (NSF-PIRE grant contract #1545852) and UC Riverside’s Office of Research and Economic Development.