Rewriting the Rules of Magnetism: How Laser Pulses Could Redefine Data Storage

International researchers have established a 25 nm spatial limit for the all-optical switching of magnetization, essential for advancing high-density data storage technologies, due to rapid electron cooling at the nanoscale.

Magnetization can be switched using a single laser pulse, but it remains unclear whether the underlying microscopic process can be scaled down to the nanometer level, a necessary step for this technology to be viable in future data storage applications.

Researchers at the Max Born Institute in Berlin, Germany, in collaboration with colleagues at the Instituto de Ciencia de Materiales in Madrid, Spain, and the free-electron laser facility FERMI in Trieste, Italy, have determined a fundamental spatial limit for light-driven magnetization reversal.

Modern magnetic hard drives can store more than one terabit of data per square inch, which means that the smallest unit of information can be encoded on an area smaller than 25 nanometers by 25 nanometers. In laser-based, all-optical switching (AOS), magnetically encoded bits are switched between their “0” and “1” state with a single ultrashort laser pulse.

To realize the full potential of AOS, particularly in terms of faster write/erase cycles and improved power efficiency, we thus need to understand whether a magnetic bit can still be all-optically reversed if its size is on the nanometer-scale.

Understanding the Process and Limitations of AOS

For AOS to take place, the magnetic material has to be heated up to very high temperatures in order for its magnetization to be reduced close to zero. Only then, its magnetization can be reversed. The twist in AOS is that in order to mediate magnetic switching, it is sufficient to heat only the electrons of the material while leaving the lattice of atomic nuclei cold.

This is exactly what an optical laser pulse does: it interacts only with the electrons, allowing to reach much higher electron temperatures with very low power levels. However, since hot electrons cool very rapidly by scattering with the cold atomic nuclei, the magnetization must be reduced sufficiently fast within this characteristic time scale, i.e. AOS relies on a careful balance between the evolution of the electron temperature and the loss of magnetization.

It is easy to see that this balance is changed when the optical excitation is confined to the nanoscale: now electrons can not only lose energy by “giving atomic nuclei a kick”, but they can also simply leave the nanometer-small hot regions by diffusing away. As they only have to traverse a nanometer-small distance in order to do so, this process also happens on ultrafast time scale, such that the electrons may cool too quickly, the magnetization is not sufficiently decreased, and AOS breaks down.

Experimental Insights into Nanoscale AOS

An international team of researchers has for the first time successfully addressed the question of “how small does AOS work” by combining experiments with soft x-rays with atomistic spin dynamics calculations. They produced an extremely short-lived pattern of dark and bright stripes of laser light at the sample surface of the prototypical magnetic material GdFe, by interference of two soft X-ray laser pulses with a wavelength of 8.3 nm. This allowed reducing the distance between dark and bright areas to only 8.7 nm.

This illumination is only present for about 40 femtoseconds, leading to a lateral modulation of hot and cold electron temperatures in the GdFe with a corresponding localized loss of magnetization. The scientists could then follow how this pattern evolves on the very short time scales that are relevant. Towards this end, a third soft X-ray pulse with the same wavelength of 8.3 nm was diffracted off the transient magnetization pattern at different time delays from the patter-generating pulses. At this particular wavelength, an electronic resonance at the gadolinium atoms allows the soft X-ray pulse to “feel” the presence of magnetization and thus the change of the magnetization can be detected with femtosecond temporal and sub-nanometer spatial resolution. Combining the experimental results with state-of-the-art simulations, the researchers could determine the ultrafast energy transport on the nanometer scale.

It turns out that the minimum size for AOS in GdFe alloys, induced by a nanoscale periodic excitation, is around 25 nm. This limit is due to ultrafast lateral electron diffusion, which rapidly cools the illuminated regions on these tiny length scales and ultimately prevents AOS. The faster cooling due to electron diffusion can be compensated to some extent by increasing the excitation power, but this approach is ultimately limited by the structural damage caused by the intense laser beam. The researchers expect that the 25 nm boundary is rather universal for all metallic magnetic materials.

Reference: “Exploring the Fundamental Spatial Limits of Magnetic All-Optical Switching” by Felix Steinbach, Unai Atxitia, Kelvin Yao, Martin Borchert, Dieter Engel, Filippo Bencivenga, Laura Foglia, Riccardo Mincigrucci, Emanuele Pedersoli, Dario De Angelis, Matteo Pancaldi, Danny Fainozzi, Jacopo Stefano Pelli Cresi, Ettore Paltanin, Flavio Capotondi, Claudio Masciovecchio, Stefan Eisebitt and Clemens von Korff Schmising, 29 May 2024, Nano Letters.
DOI: 10.1021/acs.nanolett.4c00129

Never miss a breakthrough: Join the SciTechDaily newsletter.
Follow us on Google and Google News.